G'day New here- but im puzzled over a project

[startarot]

Hey all - I am currently making a Manual Cylindrical screen printer
the only problem is i can do is the frame etc, but the rollers
i have the trouble of making them or where to start..

Here is a example of the project i am stuck with..thanks in advance

[crowie]

G'Day & Welcome to a top forum "startarot".
There are a heap of members in and around the country plus the world.
Sorry but can't help much on your question except to say ensure the shaft is lubricated & you have washers either side of the rollers.
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP photos with build notes.
Enjoy the forum.
Enjoy your woodwork.
Cheers crowie

[tdrumnut]

Welcome aboard, may your journey be a pleasant one.

[JJF]

Welcome to a forum

[Christos]

I am going to guess that you might want these rollers made out of wood so take a look at the Wood turning sub-section of the forum and post the question there.

WOODTURNING - GENERAL (http://www.woodworkforums.com/f8/)

And welcome to the forum.

[bundy253]

the wheels look like skate board wheels (I would buy a cheap skate board from kmart you get wheels bearings etc)