Reno RSS Feed
10th June 2012, 03:10 PM
Hi,
I'm owner building and am at the stage of fittng architraves. There are a few spots where the 65mm architraves just won't fit. These are the scenarios I have so would appreciate some ideas:
1. Door jamb is right up against wall. These are pretty much all inside built in robes so I figure a piece of quad woud solve this one.
2. Door jamb very close to wall (under 65mm). Should I try and trim the architrave with a table saw to fit?
3. Double windows less than 130mm apart, so an architrave on each won't fit. Should I trim both pieces half the gap and fit them back to back?
Any ideas appreciated.
Cheers,
MJ
Read and reply to the full thread at RenovateForum.com.... (http://www.renovateforum.com/f84/not-enough-room-architraves-104824/)
I'm owner building and am at the stage of fittng architraves. There are a few spots where the 65mm architraves just won't fit. These are the scenarios I have so would appreciate some ideas:
1. Door jamb is right up against wall. These are pretty much all inside built in robes so I figure a piece of quad woud solve this one.
2. Door jamb very close to wall (under 65mm). Should I try and trim the architrave with a table saw to fit?
3. Double windows less than 130mm apart, so an architrave on each won't fit. Should I trim both pieces half the gap and fit them back to back?
Any ideas appreciated.
Cheers,
MJ
Read and reply to the full thread at RenovateForum.com.... (http://www.renovateforum.com/f84/not-enough-room-architraves-104824/)