PSP7 tutorials

[jow104]

Here's a site with psp6/7/8 tutorials by the hundred., and some worthwhile surfing as well. I'm expecting it to keep me busy for a while :eek:

http://campratty.com/Resources/linda/sort1.html

[echnidna]

Thanks for that Woody, very helpful.
A few years ago I made a graphic that looked like a 3D brass plaque with PSP5 and have forgatten how to do it again - any suggestions.

[jow104]

Hello Bob,

Oddly enough I have just spent the past 45 minutes mucking around with brass (hinges) put them on, taken them off put them on zx'@xz.
I,m going to have to put the plane on the lower edge of each door. :eek:

Your Problem.

Start with a rectangle selection
fill it up with a nice brass colour
Vector Layer, Get a suitable font.
Look up dictionary to spell the word
Type in , perhaps lower the layer and mess around the the blend modes and opacities of each layer.
Or perhaps its in the Effects filters. You could look through.
Type 3D fonts in Google
Sorry Bob going planing :D

[jow104]

Bob

This one should sort you out

http://forums.jasc.com/default.asp?action=10&fid=9
You most probably will need to register if yuou want to post on forum

John

[jow104]

Bob

Keep an eye on this link your problem requested

http://www.digitalphotoclubuk.com/viewforum.php?f=2&sid=dfd85d56e081691a712973ade6c96859

John

[jow104]

http://www.digitalphotoclubuk.com/viewtopic.php?p=51#51 Bob

There is an answer to your 3D information enquiry at
http://www.digitalphotoclubuk.com/viewtopic.php?p=51#51

[jow104]

Anything like this BoB

[echnidna]

No the text was embossed.