done something stupid

[danielhobby]

Hi everyone,im a stiff semi old boilermaker from the metalworking pages and ive gone and done something stupid and paid $300 for anold oval pastry edge? breakfast?table inc four normal chairs and two carver? chairs made of oak i think?made by S wilson of 8-12 lords st richmond.Can any one tell me where i can find three pieces of oak approx 4"x1"x1'8" 100x25x500 to make new arm rests?also does anyone know anything about this manufacturer?i will post some pics when i figure out how to manipulate damned computer.cheers danny.:doh:

[toolbagsPLUS]

Hi Danny how critical is the 25mm, i have a lot of American Oak but alas not quite 25mm thick length and width fine.

Cheers


Steve

[danielhobby]

hi steve,i'll dress that dimension down to about 22/23ish mm,not quite sure as i dont have piece with me and i didnt measure it,will know more this weekend,thanks for reply,regards danny.